top of page

11. Overglaze Painting and Firing

Arranging the pieces at the center height of the kiln, away from the flames.
11-4, Unloading
Letting the kiln cool naturally for about a day, then removing the pieces from the kiln.
11-1, Applying liquid gold, silver, palladium and overglaze enamel.
・Liquid gold, silver, and palladium, as well as overglaze enamels are applied to the pieces after firing.
・I use separate brushes and small plates for each metal when I apply liquid gold, silver, and palladium, I generally use these liquid solutions undiluted, but if the viscosity is too high, I add a small amount of overglaze thinner. I also use overglaze thinner to clean the brushes and I prepare separate containers for washing each one.

・For overglaze enamels (such as *aka-e* red enamel), I place the pigment on a glass plate, add water, grind it with a square pestle, and then apply it.
11-2, Loading
​・After applying liquid gold, silver, and palladium to pieces, I allow them to dry naturally until the solvent no longer sticks to my fingers.
・The fixing temperature for metals is around 650–750°C, with slight differences in fixing temperatures for gold, silver, and matte gold. Taking these differences into account,  I arrange the pieces in the center of the kiln—at a height where they are not exposed to the flame (between the upper and lower thermocouples).


*Although the temperature for overglaze firing is close to that of bisque firing, pieces with overglaze decorations cannot be fired together with pieces for bisque firing. The large amount of water vapor generated during bisque firing negatively affects the overglaze decorations.
11-3, Overglaze firing
(h)
(℃)
Ignition 
0

















​5













 
450
650
​750
​100
I open the sliding doors to the studio and turn on the exhaust fan in the kiln room to ensure a smooth airflow and a sufficient supply of oxygen. I open the kiln damper, open the valve on the oil tank, then ignite the 4 burners. I open the air supply and adjust the oil flow, so that the flame on each burner is uniform. I close the kiln door and leave a small gap. After 30 minutes, I check the flames again and make adjustments.​
  *Damper---A plate located in the exhaust path that is opened or closed to physically allow or block the flow of gas.
​
Firing   (about 8 hours) 
Cooling   (about 24 hours)
I allow the kiln to cool naturally.
I leave the kiln door slightly open and raise the temperature to 400–450°C at a rate of about 100°C per hour. This allows gases generated by the adhesives and solvents in the liquid solutions to escape.

I close the kiln door. I work to ensure the temperature inside the kiln becomes uniform.

While monitoring the temperature readings from the upper and lower thermocouples, I calculate the temperature at the center of the kiln.

Once the target temperature is reached, I hold the temperature for about 5 to 10 minutes.


I turn off the fire, close the damper, and close the valve on the oil tank.
  • Instagram
Ari's Art Works in Kanagawa
bottom of page