top of page
Ari’s Equipment / Tools


Compressor
Ari's Tools
Tools I mainly use for forming
a, Tombo: A gauge for measuring diameter and depth.
b, Kote (wooden rib): I use a kote to tighten the center of the inside bottom.
Nameshigawa: Chamois leather for tightening the rim.
Shippiki: Cutting string
Yumi: Harp cutting tool
c, Bamboo tools: For carving and pressing
Trimming tools: For carving
d, Kanna: Trimming tools
e, Shitta: Trimming chucks are bases made on the wheel and left to semi-dry. They are used to support and stabilize vessels on a wheel while trimming the body and foot.
Sponge: For removing excess moisture and creating patterns.
f, Plaster molds: Molds are used primarily for making plates.
g, Tataraita: Guide boards used for slicing clay when making plates. Thicknesses are 5, 6, 7, 8 mm
h, Ponsu: Hole cutters are used to cut out round holes and patterns in semi-dry clay. φ 1 mm~
Others: Cord, screw, shell, comb......
I make most of my tools myself so that they fit my hands.



d

e

f

g

a

b

c

h
Tools I use for firing
a, Tsuku: Shelf supports
b, Shelves
c, Pyrometer and thermocouples: used for measuring temperatures inside the kiln, at upper and lower locations.
Kiln wadding: a clay-like material that does not harden even after firing. I use it to adjust the height of shelves and to fill gaps when inserting bricks in color-check holes or using thermocouples.
Chisel: I use a chisel to remove pieces of glaze that have melted onto kiln shelves and shelf supports.
Alumina: I mix alumina with water and apply it to areas where the alumina coating has peeled off on the kiln shelves and shelf supports.
Scrub brush: I use it to brush away dust from the backs and sides of the kiln shelves and shelf supports.


a

b

c
bottom of page





