top of page
9-1, Applying a wax-resist to the bottom
I apply a wax resist to the bottom of pieces to prevent glazes from adhering there.

The glaze melts during firing to form a glassy substance that hardens as it cools. If glaze remains on the bottom, the piece will stick to the shelf of the kiln.

​​I also apply a wax resist to areas where I don’t want the glaze to adhere. The wax resist burns off during firing.
9-2, Straining the glaze
​The glaze has sat for a long time in the bucket and settled. I pour off the supernatant water, stir the glaze thoroughly with a wooden spatula, and pass it through a 60-mesh sieve.
9-3, Glazing
I add water to the glaze to achieve the proper consistency. I measure its concentration using a Baume hydrometer. I also dip a piece of bisque into the glaze and press it with my fingernail to check the thickness of the glaze. Finally, I apply the glaze to a single piece to double-check.

The glaze settles quickly, so I stir it frequently as I apply it to the pieces. There are various ways to apply glaze. I can dip the pieces by hand, use a ladle to pour the glaze onto the pieces or spray them with a compressor.

A bisque-fired clay body absorbs moisture very well. As soon as the glaze is applied,  moisture is quickly absorbed into the clay body, causing the glaze to adhere to the surface and dry. The thickness of the glaze varies depending on how long it is applied to the piece or immersed in the glaze bucket.
DSC_0382.JPG
If a glaze is applied too thickly, glazes with low melting points will run during firing and may stick to the kiln shelf as a result.  If a glaze is too thin, it can result in a brown, scorched-finish on the clay body. Since the clay body and glaze interact during firing, the way the glaze melts depends on the type of clay used.

To achieve the glaze effect I envision, I decide on the thickness of the glaze by considering the properties of the clay and the glaze, the time and method used for glazing, and the weather conditions on the glazing day.
9-4, Wiping the glaze off the bottom
Even if wax resists are applied to the bottom of the pieces, some glaze may remain. I wipe away any excess glaze with a damp sponge. I also check the entire piece, and if there are any areas where glaze is needed, I apply it with a brush.

The glaze on bisque-fired pieces comes off easily, so I try not to touch the pieces more than necessary. When handling a piece, I hold it by pinching gently with my finger pads. When handling pieces coated with different types of glaze, I wipe my fingers before picking them up.
  • Instagram
Ari's Art Works in Kanagawa
bottom of page