top of page
4. Forming methods
Hand-building
A method of rolling clay into ropes and stacking them. It allows for the creation of large pieces and free-form shapes.

I stack one layer of rope-shaped clay, pressing it together with fingers to join the pieces, and tap it with a board, and use fingers to smooth out the seams. And I continue stacking more rope-shaped clay.

I stack the ropes one layer at a time, pressing them down with fingers and tapping them with a board to shape them into a rough final form. I take care to prevent them from drying out.


I add clay, carve it away, and build up the details. I always pay close attention to the moisture content of the clay.
Wheel-throwing
A method that uses rotational force. It allows you to make many similar items quickly.
I place the spiral wedging clay in the center of the wheel, and spin the wheel, and center the clay. (Centering)

On the wheel, I form a piece by using my hands. And I tighten the center of the bottom with a wooden rib, place a Tombo (size gauge) against it to check the size, and tighten the rim with chamois leather strip. I cut the piece with a cutting thread and place it on a board. I take care of the clay's condition as it dries to ensure that the pieces reach a suitable hardness for trimming.


I place a piece over the trimming chuck and trim the foot.

*Each photo shows a step in the process for a different piece.
Slab-building
A method of forming clay into flat sheets. Used to make plates and tiles.

I place guide boards on both sides of the clay, and slice it with a cutting wire while removing the boards one set at a time. I arrange the sliced clay pieces one by one, and take care that the moisture in the clay pieces dries evenly until the clay becomes suitable for forming.
Forming using slab thickness sticks.
Mainly for small plates and such.
I tighten both sides of the clay slab using a wooden rib, cut it using a template, and form it by finger pressing the slab pieces, one by one. If using a plaster mold, I tap it tightly.
I place the pieces on a wood board, taking care to ensure that each piece dries slowly and evenly, compressing them several times with fingers or a rib while they are drying.

Forming using a slab roller.
Mainly for large plates and tiles.
I thoroughly pound a lump of clay, then roll it out using a slab roller set to a slightly thicker setting than the desired final thickness. Then I reduce the roller’s thickness as I roll out the slab several times. I take care to remove moisture evenly and slowly from the slab until it reaches a suitable hardness for forming.
I cut the slab using a template, and tighten its edges with my fingers or a wooden rib. If I need to reform the slab, I tighten the body of the slab and not just the edges.
bottom of page


